Römheld - New block cylinder “S” for presses and punches

It is hydraulically double-acting and universally applicable for all linear movements with high force requirements. The block cylinder S can withstand high mechanical and thermal loads and is suitable for operating pressures up to 500 bar and operating temperatures up to 200 °C. Versions up to 250 °C are available on request.

Block cylinder S absorbs high loads and side loads

The block cylinder S shows its strengths in particular where high loads and side loads are to be expected, for example on punches, presses, trimming, bending and stamping machines as well as in joining and press-in devices. All designs are equipped with piston and rod guide rings which absorb side loads between the moving components. These also prevent direct metal contact between piston and cylinder housing, minimising mechanical wear. The operating pressure of the block cylinder S must be limited to 250 bar for these applications because of the very high loads during punching due to the cutting impact.

Many application possibilities

Thanks to numerous variants and small dimensions, the block cylinder S can also be used for a wide range of applications. For example, core pullers and sliders can be operated in mould making. It can also be used in fully automatic production systems with very short cycle times thanks to its high load capacity. Inductive stroke end controls are provided for optional position monitoring.

Five designs: different piston diameters, strokes, sealing systems

Five sizes with piston diameters from 32 to 80 mm and four stroke lengths from 25 to 100 mm are available. If required, the standard stroke can be shortened by 5 to 29 mm by means of a shrunk-on distance bushing. Piston variants with internal or external thread are available.

Five different sealing systems are available depending on the application conditions. By combining different sealing materials, the sealing system can be optimally adapted to the respective operating pressure, operating temperature and hydraulic fluid. This ensures that the piston moves constantly and smoothly even at low speeds, i.e. without a stick-slip effect.

High load capacity, protected against dirt, variable connections

To meet the high mechanical and thermal requirements, the threaded bushing, cylinder housing and internal piston stops of the block cylinder S have been reinforced. The rod seals with minimum leakage ensure clean operation. The newly designed dirt wiper prevents the penetration of coarse dirt or swarf. It is countersunk to such an extent that the sealing lip is largely protected.

The block cylinder can be fixed in various ways. For this purpose, bore holes are available on the broad side, the rod side and the bottom side. There is also a whole range of different connecting options for hydraulics by means of pipe or flange, all with generously dimensioned diameters for high flow rates.

Load diagrams help to select the correct model

The selection of the correct model variant is facilitated by a series of clear diagrams which show the customer the respective load limits for all possible operating conditions. At a glance, the admissible side loads as a function of the piston stroke, the permitted piston speeds in relation to the fixed mass and the appropriate seal combinations for the respective application can be seen.